TowerPro 9g digital servo New version of SG90. POM with Carbon fiber gears set and control arms are more durable use than SG90 nylon gear and more torque. It is a good choice for park size 3D models , high speed jets and R/C airplane 250 450 RC helicopter.

Tiny little servo can rotate approximately 180 degrees (90 in each direction), and works just like the standard kinds you're used to butsmaller. You can use any servo code, hardware or library to control these servos. Good for beginners who want to make stuff move without building a motor controller with feedback & gear box, especially since it will fit in small places. Of course, its not nearly as strong as a standard servo. Works great with the Motor Shield for Arduino or by just wiring up with the Servo library. Comes with a few horns and hardware.

To control with an Arduino, we suggest connecting the orange control wire to pin 9 or 10 and using the Servo library included with the Arduino IDE (see here for an example sketch). Position "0" (1.5ms pulse) is middle, "90" (~2ms pulse) is all the way to the right, "-90" (~1ms pulse) is all the way to the left.

Specifications:

• Weight: 9g

• Dimension: 23×12.2x27mm

• Stall torque: 2.5kg /cm(4.8v)

• Gear type: POM with carbon fiber

• Operating speed: 0.1sec /60degree (4.8v)

• Operating voltage: 4.8v

• Temperature range: 0¿_ 55¿

• Dead band width:1us

• servo wire length: 25 cm

• Servo Plug: JR (Fits JR and Futaba)

• servo arms &screws included and fit with Futaba servo arm

• It’s universal “S” type connector that fits most receivers, including Futaba, JR, Hitec ,GWS, Cirrus, Blue Bird, Blue Arrow, Corona, Berg, Spektrum.

• CE &RoHS approved

Product Description